Graham Field Bathroom Aids 7921R User Manual

7921R / 7931R: BATH SEAT  
ASSEMBLY & OPERATION INSTRUCTIONS  
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE  
Note: The most current version of these instructions can be found online at www.grahamfield.com  
WARNING: Important! Read and understand these instructions before assembling or using the  
Bath Seat. If you do not understand any part of these warnings, cautions or instructions, contact  
a healthcare professional for direction in the use of this product. If the Bath Seat is not properly  
assembled and adjusted, personal injury and damage to the Bath Seat could result.  
WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT use  
substitute parts. Use only Lumex replacement parts. Non-Lumex replacement parts could cause  
personal injury and damage to the Bath Seat.  
WARNING: This product has a weight limit of 350 lb.  
WARNING: DO NOT use this product as a transfer bench or climbing device.  
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury caused by  
improper assembly or use of this product.  
ASSEMBLY  
1. Remove the Bath Seat from the box and place it on a flat, dry surface.  
figure 1  
figure 2  
figure 3  
figure 4  
2. Locate the seat legs (see figure 1).  
3. Locate the shortest screw knob and a curved washer (see figure 2).  
4. Lay legs in “X” pattern over seat bottom (see figures 3 and 4).  
WARNING: Legs must be positioned exactly as shown in figure 3 for a safe and proper fit.  
5. Install curved washer on screw knob. Fasten legs to seat by inserting screw knob through center leg  
holes into seat and turning screw knob clockwise. Ensure screw knob is tight without overtightening.  
WARNING: Ensure legs are securely installed and all hardware is tight before proceeding.  
Note: If you are assembling 7921R (with backrest), proceed to step 6.  
If you are assembling 7931R (without backrest), proceed to step 8b.  
6. Locate backrest tubes, backrest, four  
screw knobs, and four curved washers  
(see figure 5).  
7. See figure 6. Install curved washers on  
screw knobs. Install backrest tubes on  
backrest. Attach backrest tubes to back-  
rest by inserting screw knobs through  
backrest holes into backrest and turning  
the screw knobs clockwise. Ensure screw  
figure 5 (7921R)  
figure 6 (7921R)  
knobs are tight without overtightening.  
Caution: Do not overtighten screw knobs.  
GF0500057RevD10  
1
 

Haier Flat Panel Television 24D2000 User Manual
HANNspree Flat Panel Television K226 10C1 User Manual
Harbor Freight Tools Kitchen Utensil 94559 User Manual
Harbor Freight Tools Vacuum Cleaner 95834 User Manual
Heath Zenith Door SL 6166 User Manual
Honeywell All in One Printer VG1250gAP QS User Manual
HP Hewlett Packard Laptop XZ100 User Manual
HP Hewlett Packard Network Router 2100 ER User Manual
Hubbell Network Cables 69320 101 User Manual
i Tech Dynamic Headphones Buzzer Clip User Manual